Amana Dryer Error Code 6E: Meaning and Fix

How 6E appears on a Amana dryer display.

Amana dryer Timer (part number W10857612), the component to check for code 6E (shared reference photo for this part type) — Product photo courtesy of AppliancePartsPros.com

Reading the dryer display

On a dryer the code shows in the time-remaining window or as blinking status lights. Write down the characters before you press anything, because starting a new cycle usually clears the display. Amana models often flash lights instead of printing text, so count the flashes.

Amana is a Whirlpool Corporation brand sold mostly through builder and value channels. Its entry-level washers, dryers and ranges use the simpler Whirlpool-family control boards, so the codes are short and often shown as flashing lights. The codes apply to model numbers such as ADB1200AWS, ADB2200AWS and NDE2330AYW; check the label on your unit to confirm yours.

What causes 6E

Wiring harness between boards is loose, damaged or corroded
A brief power surge confused the control
A downstream part is drawing too much current and tripping the board
Main control board has a failed relay, driver or memory chip

How to fix it

Cycle the power: switch off the dryer breaker (or unplug it) for one minute, restore power, then start a timed dry cycle and watch for the code.
Reset power and see whether the code clears; note when it returns (at start, mid-cycle, at random).
Inspect all harness plugs on the main board for heat discoloration, loose pins or pinched wires.
Check the wiring diagram for the model and test the circuit named by the code for continuity.
Replace the main control board only after the harness and the part it drives test good.
Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.

Parts you may need

Part	Part no.	Buy
Timer	W10857612	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does 6E mean on a Amana dryer?

It is a fault code from the Amana control. It indicates a problem with the control electronics. A power reset is the first thing to try.

Can I keep using the dryer while it shows 6E?

You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.

Do I need a technician to clear 6E?

Often yes. Part of this repair means testing live circuits or replacing a control board, so a technician is the safer choice unless you are comfortable with electrical diagnosis.

Other Amana dryer codes

Amana dryer Timer (part number W10857612), the component to check for code 0E

0EControl electronics fault

Amana dryer Timer (part number W10857612), the component to check for code 0g (shared reference photo for this part type)

0gControl electronics fault

Amana dryer Timer (part number W10857612), the component to check for code 3E (shared reference photo for this part type)

3EControl electronics fault

Amana dryer Timer (part number W10857612), the component to check for code E1 (shared reference photo for this part type)

E1Control electronics fault

Amana dryer Timer (part number W10857612), the component to check for code E2 (shared reference photo for this part type)

E2Control electronics fault

Amana dryer Timer (part number W10857612), the component to check for code E3 (shared reference photo for this part type)

E3Control electronics fault

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including NDE2330AYW, NDE2335AYW, NDE7800AYW, NDG2330AWW, NDG7800AWW, NDE5800AYW.