Home Fault Codes

Amana Microwave Error Code E23: Meaning and Fix

E23
How E23 appears on a Amana microwave display.
Amana microwave Fuse (part number WP8183507), the component to check for code E23 (shared reference photo for this part type)
Product photo courtesy of AppliancePartsPros.com

Reading the microwave display

On a microwave the code replaces the clock on the display. Unplug the unit for a minute to see if it clears, and note the code before you do. Amana models often flash lights instead of printing text, so count the flashes.

Amana is a Whirlpool Corporation brand sold mostly through builder and value channels. Its entry-level washers, dryers and ranges use the simpler Whirlpool-family control boards, so the codes are short and often shown as flashing lights. The codes apply to model numbers such as ADB1200AWS, ADB2200AWS and NDE2330AYW; check the label on your unit to confirm yours.

What causes E23

How to fix it

  1. Cycle the power: unplug the microwave (or switch off its breaker) for one minute, restore power and test it briefly with a cup of water.
  2. Before opening any panel, switch off the breaker or unplug the appliance; this circuit can carry line voltage.
  3. Confirm the power supply is correct (both legs of the 240 V circuit on electric units) or that the gas shutoff is open on gas units.
  4. Inspect the element, igniter or burner for visible blistering, cracks or debris.
  5. With power disconnected, test the element or igniter for continuity with a multimeter; infinite resistance means it has failed.
  6. Replace the failed heater, igniter or limit device, then run a short test cycle to verify heat.
  7. Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.

Parts you may need

PartPart no.Buy
FuseWP8183507Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does E23 mean on a Amana microwave?

It is a fault code from the Amana control. It indicates a problem with the heating circuit. A power reset is the first thing to try.

Can I keep using the microwave while it shows E23?

Stop using it until it has been checked. This fault involves heat, high voltage or sealed-system parts, and running it can damage the appliance or create a safety risk.

Do I need a technician to clear E23?

Often yes. Part of this repair means testing live circuits or replacing a control board, so a technician is the safer choice unless you are comfortable with electrical diagnosis.

Other Amana microwave codes

Amana microwave Control Panel Switch (part number 53001491), the component to check for code E03E03Control panel faultAmana microwave Fuse (part number WP8183507), the component to check for code E11E11Temperature sensor faultAmana microwave Fuse (part number WP8183507), the component to check for code E12 (shared reference photo for this part type)E12Temperature sensor faultAmana microwave Board Control (part number 53001081), the component to check for code E13E13Control electronics faultAmana microwave Fuse (part number WP8183507), the component to check for code E21 (shared reference photo for this part type)E21Temperature sensor faultAmana microwave Fuse (part number WP8183507), the component to check for code E22 (shared reference photo for this part type)E22Temperature sensor fault

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including AMV5206AAQ, ACO1560AB, AMV5206AAS, AMC5143AAS, AMV5206BAS, AMC2206BAS.