Bosch Dishwasher Error Code E07: Meaning and Fix
Reading the dishwasher display
A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Bosch shows the code with a leading E and a number on both dishwashers and washers.
Bosch (part of BSH Home Appliances) uses E-numbered codes on dishwashers and washers. Its dishwashers share control platforms with Thermador and Gaggenau, so the same fault can appear on those brands. The codes apply to model numbers such as SHPM65Z55N, SHE53T55UC and WAT28400UC; check the label on your unit to confirm yours.
What causes E07
- Low household water pressure or a half-closed shutoff valve
- A failing inlet valve solenoid that opens slowly, sticks open or does not open at all
- A clogged mesh screen on the inlet valve or a kinked fill hose
- A flow meter or turbidity/level sensor that is not counting water
How to fix it
- Cancel the cycle and make sure the hot and cold supply valves behind the machine are fully open.
- Turn off the water, disconnect the fill hose and rinse the small filter screen at the valve inlet to clear sediment.
- Listen for the inlet valve; if it clicks but no water enters, the screen is likely blocked.
- Inspect the hose for kinks and test another faucet in the home to confirm pressure is normal.
- Reconnect, restore power and start a short cycle while listening for the valve clicking and water running in.
- If water still fails to arrive (or never stops), measure the valve coil with a multimeter and replace the inlet valve if it is out of range.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Dishwasher Water Inlet Valve | 10023852 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does error E07 mean on a Bosch dishwasher?
The dishwasher waited too long for the correct water level and gave up the cycle. Exact behavior can vary by model and software version; confirm against your own manual.
Can I keep using my dishwasher while E07 is showing?
Only briefly. A machine that cannot fill correctly will wash poorly and, if the valve sticks open, can overflow, so shut the water off at the wall when it is idle.
How do I clear E07, and can I fix it myself?
Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. Parts here involve electronics, heating or sealed components, so consider a qualified technician if the basic checks do not clear it.
Other Bosch dishwasher codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including SHPM65Z55N, SHE53T55UC, SHX53TL5UC, SHEM63W55N.