Home Fault Codes

Bosch Washer Error Code E19: Meaning and Fix

E19
How E19 appears on a Bosch washer display.
Representative Bosch washer part photo (a drain pump unit); the specific component for E19 (heater fault (alternate)) was not photographed separately
AppliancePartsPros.com product photo

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Bosch shows the code with a leading E and a number on both dishwashers and washers.

Bosch (part of BSH Home Appliances) uses E-numbered codes on dishwashers and washers. Its dishwashers share control platforms with Thermador and Gaggenau, so the same fault can appear on those brands. The codes apply to model numbers such as SHPM65Z55N, SHE53T55UC and WAT28400UC; check the label on your unit to confirm yours.

What causes E19

How to fix it

  1. Switch the appliance off at the breaker and let it cool completely before working on it.
  2. Inspect the heater wiring and connectors for scorching, looseness or corrosion and reseat them.
  3. Clean and reseat the terminals, checking for water spots.
  4. Test the heating element and the temperature sensor for continuity/resistance with a multimeter against the values in your service sheet.
  5. Replace whichever component fails the test; never bypass a thermal fuse.
  6. Reassemble, restore power and run a hot cycle, checking that the water or air reaches temperature in a normal time.

Parts you may need

PartPart no.Buy
Washer Drain Pump00144486Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does error E19 mean on a Bosch washer?

The heater circuit is not reaching or maintaining temperature as the board expects. Exact behavior can vary by model and software version; confirm against your own manual.

Can I keep using my washer while E19 is showing?

You can run cold or short cycles in a pinch, but results will be poor, and a heater that stays on is a safety concern, so repair it soon.

How do I clear E19, and can I fix it myself?

Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. Parts here involve electronics, heating or sealed components, so consider a qualified technician if the basic checks do not clear it.

Other Bosch washer codes

Representative Bosch washer part photo (a drain pump unit); the specific component for E13 (heating fault) was not photographed separatelyE13Heating faultBosch washer water inlet valve part photo, the component usually involved when E17 (water supply / fill fault) appearsE17Water supply / fill faultBosch washer drain pump part photo, the component usually involved when E18 (drain fault) appearsE18Drain faultBosch washer door seal part photo, the component usually involved when E23 (leak / water in the base) appearsE23Leak / water in the baseBosch washer shock absorber part photo, the component usually involved when E32 (unbalanced load) appearsE32Unbalanced loadRepresentative Bosch washer part photo (a drain pump unit); the specific component for E01 (control / power electronics fault) was not photographed separatelyE01Control / power electronics fault

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including WAT28400UC, WAT28402UC, WAW285H1UC, WAP24200UC.