Frigidaire Dishwasher Error Code i30: Meaning and Fix

A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Frigidaire models show E, F or i codes depending on the appliance.

Frigidaire is an Electrolux brand and shares platforms with the Electrolux line. Washers and dryers use E codes, ranges use F codes, dishwashers use i codes, and refrigerators show SY codes. The codes apply to model numbers such as FGID2466QF, FFBD2412SW and FFRE4120SW; check the label on your unit to confirm yours.

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

What does the i30 code mean on a Frigidaire dishwasher?

The base pan float or level sensor reports water where it should not be.

Can I fix the i30 code myself?

Start with the free checks (power reset, connectors, obvious blockages). The likely repair involves the water inlet valve and live-circuit testing, so if the code returns, a qualified technician is the safer call.

How do I clear the i30 code?

Switch off the dishwasher breaker or hold Cancel/Drain, wait a few minutes and run a short rinse. If i30 comes back, the underlying fault is still there; start with this: leaking door gasket or hose.

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including FGID2466QF, FFBD2412SW, FDPC4221AS.

• https://www.appliancepartspros.com/frigidaire-valve-water-inlet-5304525044-ap6988433.html
• https://www.appliancepartspros.com/frigidaire-valve.html