Maytag Dishwasher Error Code 8 Pause 1 Pause: Meaning and Fix
Also shown as: 8Pause1Pause, 8-Pause-1-Pause
Reading the dishwasher display
A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Maytag shares the Whirlpool pairing: read the first group, then the sub-code that follows it.
Maytag appliances are built by Whirlpool Corporation on shared platforms, which is why Maytag codes often match Whirlpool ones. Maytag washers, dryers and ranges commonly show F-codes with an E sub-code, or flashing keypad lights. The codes apply to model numbers such as MDB7600AWB, MDB7600AWW and PYE2300AYW; check the label on your unit to confirm yours.
What causes 8 Pause 1 Pause
- The not detecting water (or its connector and wiring) has failed or come loose
- Water taps are closed or only partly open
- Low household water pressure
- Inlet valve coil or solenoid is open or stuck
- Level or flow sensor is giving the control a wrong reading
- Inlet hose is kinked or the screen at the hose end is clogged
How to fix it
- Cycle the power: switch off the dishwasher breaker for about a minute (or unplug it if you can reach the cord), restore power and run a short cycle.
- Confirm both hot and cold taps are fully open and the supply hoses are not kinked or crushed behind the unit.
- Disconnect the hoses, clean the small screens at the valve inlets and flush each hose into a bucket to check flow.
- Run a short cycle and listen for the valve to click and water to arrive; note whether the level rises.
- If the valve does not open, check its connector and coil, then replace the inlet valve if the coil is open.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Valve Inlet | W11175771 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does 8 Pause 1 Pause mean on a Maytag dishwasher?
It is a fault code from the Maytag control. It indicates a problem with the water fill circuit, specifically the not detecting water. A power reset is the first thing to try.
Can I keep using the dishwasher while it shows 8 Pause 1 Pause?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear 8 Pause 1 Pause?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Maytag dishwasher codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including MDB7600AWB, MDB7600AWW, MDB9100AWW, MDB8600AWW, MDB7100AWW, MDB7100AWB, MDB6000AWW, MDB9100AWB.