Maytag Microwave Error Code F6: Meaning and Fix
Reading the microwave display
On a microwave the code replaces the clock on the display. Unplug the unit for a minute to see if it clears, and note the code before you do. Maytag shares the Whirlpool pairing: read the first group, then the sub-code that follows it.
Maytag appliances are built by Whirlpool Corporation on shared platforms, which is why Maytag codes often match Whirlpool ones. Maytag washers, dryers and ranges commonly show F-codes with an E sub-code, or flashing keypad lights. The codes apply to model numbers such as MDB7600AWB, MDB7600AWW and PYE2300AYW; check the label on your unit to confirm yours.
What causes F6
- Wiring harness between boards is loose, damaged or corroded
- A brief power surge confused the control
- Main control board has a failed relay, driver or memory chip
- A downstream part is drawing too much current and tripping the board
How to fix it
- Cycle the power: unplug the microwave (or switch off its breaker) for one minute, restore power and test it briefly with a cup of water.
- Before opening any panel, switch off the breaker or unplug the appliance; this circuit can carry line voltage.
- Reset power and see whether the code clears; note when it returns (at start, mid-cycle, at random).
- Inspect all harness plugs on the main board for heat discoloration, loose pins or pinched wires.
- Check the wiring diagram for the model and test the circuit named by the code for continuity.
- Replace the main control board only after the harness and the part it drives test good.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Board Control | 53001081 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F6 mean on a Maytag microwave?
It is a fault code from the Maytag control. It indicates a problem with the control electronics. A power reset is the first thing to try.
Can I keep using the microwave while it shows F6?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F6?
Often yes. Part of this repair means testing live circuits or replacing a control board, so a technician is the safer choice unless you are comfortable with electrical diagnosis.
Other Maytag microwave codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including MMV4205BAW, MMV4205BAS, MMV5000ADW, MMV4205BAB, CMV1000ADW, MMV1153AAW, MMV4205AAS, MMV5156AAS.