Maytag Washer Error Code F0 E5: Meaning and Fix
Also shown as: F0E5, F0-E5
Reading the washer display
On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Maytag shares the Whirlpool pairing: read the first group, then the sub-code that follows it.
Maytag appliances are built by Whirlpool Corporation on shared platforms, which is why Maytag codes often match Whirlpool ones. Maytag washers, dryers and ranges commonly show F-codes with an E sub-code, or flashing keypad lights. The codes apply to model numbers such as MDB7600AWB, MDB7600AWW and PYE2300AYW; check the label on your unit to confirm yours.
What causes F0 E5
- Water taps are closed or only partly open
- Inlet valve coil or solenoid is open or stuck
- Low household water pressure
- Level or flow sensor is giving the control a wrong reading
- Inlet hose is kinked or the screen at the hose end is clogged
How to fix it
- Cycle the power: unplug the washer (or switch off its breaker) for five minutes, restore power, then start a short cycle and see whether the code returns.
- Confirm both hot and cold taps are fully open and the supply hoses are not kinked or crushed behind the unit.
- Disconnect the hoses, clean the small screens at the valve inlets and flush each hose into a bucket to check flow.
- Run a short cycle and listen for the valve to click and water to arrive; note whether the level rises.
- If the valve does not open, check its connector and coil, then replace the inlet valve if the coil is open.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Valve | W11165546 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F0 E5 mean on a Maytag washer?
It is a fault code from the Maytag control. It indicates a problem with the water fill circuit. A power reset is the first thing to try.
Can I keep using the washer while it shows F0 E5?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F0 E5?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Maytag washer codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including MAH4000AWW, PAV2300AWW, MAH5500BWW, MAH3000AWW, FAV6800AWW, MAH8700AWW, MAV6200AWW, PAVT234AWW.