Home Fault Codes

Speed Queen Dryer Error Code E6: Meaning and Fix

E6
How E6 appears on a Speed Queen dryer display.
Representative Speed Queen dryer part photo (a heating element unit); the specific component for E6 (restricted airflow) was not photographed separately
AppliancePartsPros.com product photo

Also shown as: E-6

Reading the dryer display

On a dryer the code shows in the time-remaining window or as blinking status lights. Write down the characters before you press anything, because starting a new cycle usually clears the display. Speed Queen shows two characters such as Ed or E1 on the control.

Speed Queen, from Alliance Laundry Systems, builds commercial-grade home laundry. Its washers and dryers use short error codes such as E1 or Ed, and the control is simpler than most consumer brands, which makes diagnosis more direct. The codes apply to model numbers such as DR7, DC5 and TR7; check the label on your unit to confirm yours.

What causes E6

How to fix it

  1. Unplug the dryer and clean the lint screen and the housing underneath it.
  2. Pull the dryer forward, disconnect the vent hose and clear lint from the hose, wall duct and exterior flap.
  3. Shorten and straighten the vent duct.
  4. Check the vent is rigid or semi-rigid metal, short, and free of sags and kinks.
  5. Clean out the blower housing if you can access it, then reconnect the duct.
  6. Run a timed dry and confirm hot air flows freely at the outside vent.

Parts you may need

PartPart no.Buy
Dryer Heating ElementD510329PFind part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does error E6 mean on a Speed Queen dryer?

The dryer sees a very slow temperature rise due to bad airflow. Exact behavior can vary by model and software version; confirm against your own manual.

Can I keep using my dryer while E6 is showing?

Stop using it until the vent is clear; restricted airflow overheats the dryer and is a real fire risk.

How do I clear E6, and can I fix it myself?

Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. This one is usually a do-it-yourself job with basic tools.

Other Speed Queen dryer codes

Representative Speed Queen dryer part photo (a heating element unit); the specific component for E1 (inlet temperature sensor fault) was not photographed separatelyE1Inlet temperature sensor faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E2 (exhaust temperature sensor fault) was not photographed separatelyE2Exhaust temperature sensor faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E3 (moisture sensor / control fault) was not photographed separatelyE3Moisture sensor / control faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E4 (door switch fault) was not photographed separatelyE4Door switch faultSpeed Queen dryer heating element part photo, the component usually involved when E5 (heating fault) appearsE5Heating faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E7 (motor fault) was not photographed separatelyE7Motor fault

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including DR7, DC5, ADE9RGS, LDE30.