Whirlpool Dishwasher Error Code F3E2- Dishwasher: Meaning and Fix
Also shown as: F3E2Dishwasher, F3E2--Dishwasher
Reading the dishwasher display
A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Whirlpool-family codes are usually read as a letter and number pair, with an E sub-code after it.
Whirlpool is the parent platform for Maytag, KitchenAid and Amana, so many of its control boards and fault codes reappear across those brands. Its panels typically report two-part codes such as F5 E2 or flash sequences on the keypad. The codes apply to model numbers such as GU980SCGB2, GU980SCGQ2 and GEW9200LW0; check the label on your unit to confirm yours.
What causes F3E2- Dishwasher
- The thermistor (or its connector and wiring) has failed or come loose
- Airflow restriction made the appliance run hotter than it should
- Sensor has drifted, opened or shorted out
- Sensor harness is loose, pinched or corroded at the connector
- Thermal fuse or high-limit device has tripped
- Control board is misreading the sensor signal
How to fix it
- Cycle the power: switch off the dishwasher breaker for about a minute (or unplug it if you can reach the cord), restore power and run a short cycle.
- Power the unit down and let it cool, then clear any vent, filter or airflow restriction before re-testing.
- Locate the sensor named in the code and check that it is seated, undamaged and connected.
- With the connector unplugged, measure the sensor resistance with a multimeter and compare it to the chart for the model; an open or shorted reading means the sensor is bad.
- Replace the sensor (or thermal fuse) if it fails the test, then run a short cycle to confirm the code stays away.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Thermal Fuse | W10258275 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F3E2- Dishwasher mean on a Whirlpool dishwasher?
It is a fault code from the Whirlpool control. It indicates a problem with a temperature sensor, specifically the thermistor. A power reset is the first thing to try.
Can I keep using the dishwasher while it shows F3E2- Dishwasher?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F3E2- Dishwasher?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Whirlpool dishwasher codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including GU980SCGB2, GU980SCGQ2, GU980SCGQ3, GU940SCGQ2, GU940SCGB2, DU943PWKQ0, GU1200XTKB0, GU980SCGB3.