Whirlpool Dishwasher Error Code F8E2- Dishwasher: Meaning and Fix
Also shown as: F8E2Dishwasher, F8E2--Dishwasher
Reading the dishwasher display
A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Whirlpool-family codes are usually read as a letter and number pair, with an E sub-code after it.
Whirlpool is the parent platform for Maytag, KitchenAid and Amana, so many of its control boards and fault codes reappear across those brands. Its panels typically report two-part codes such as F5 E2 or flash sequences on the keypad. The codes apply to model numbers such as GU980SCGB2, GU980SCGQ2 and GEW9200LW0; check the label on your unit to confirm yours.
What causes F8E2- Dishwasher
- The fill valve electric (or its connector and wiring) has failed or come loose
- Inlet hose is kinked or the screen at the hose end is clogged
- Low household water pressure
- Water taps are closed or only partly open
- Level or flow sensor is giving the control a wrong reading
- Inlet valve coil or solenoid is open or stuck
How to fix it
- Cycle the power: switch off the dishwasher breaker for about a minute (or unplug it if you can reach the cord), restore power and run a short cycle.
- Confirm both hot and cold taps are fully open and the supply hoses are not kinked or crushed behind the unit.
- Disconnect the hoses, clean the small screens at the valve inlets and flush each hose into a bucket to check flow.
- Run a short cycle and listen for the valve to click and water to arrive; note whether the level rises.
- If the valve does not open, check its connector and coil, then replace the inlet valve if the coil is open.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Valve Inlet | W11175771 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F8E2- Dishwasher mean on a Whirlpool dishwasher?
It is a fault code from the Whirlpool control. It indicates a problem with the water fill circuit, specifically the fill valve electric. A power reset is the first thing to try.
Can I keep using the dishwasher while it shows F8E2- Dishwasher?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F8E2- Dishwasher?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Whirlpool dishwasher codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including GU980SCGB2, GU980SCGQ2, GU980SCGQ3, GU940SCGQ2, GU940SCGB2, DU943PWKQ0, GU1200XTKB0, GU980SCGB3.