Whirlpool Dryer Error Code Loc: Meaning and Fix
Reading the dryer display
On a dryer the code shows in the time-remaining window or as blinking status lights. Write down the characters before you press anything, because starting a new cycle usually clears the display. Whirlpool-family codes are usually read as a letter and number pair, with an E sub-code after it.
Whirlpool is the parent platform for Maytag, KitchenAid and Amana, so many of its control boards and fault codes reappear across those brands. Its panels typically report two-part codes such as F5 E2 or flash sequences on the keypad. The codes apply to model numbers such as GU980SCGB2, GU980SCGQ2 and GEW9200LW0; check the label on your unit to confirm yours.
What causes Loc
- The lock mechanism is not confirming that it latched or released
- Wiring or connector at the lock has corroded or backed out
- Control board is not sending or reading the lock signal correctly
- Door or lid not closing squarely, or the strike is worn or bent
How to fix it
- Cycle the power: switch off the dryer breaker (or unplug it) for one minute, restore power, then start a timed dry cycle and watch for the code.
- Open and shut the door or lid firmly and make sure nothing (clothing, a rack, a hose) is blocking the strike.
- Look at the lock and strike for cracks, bent tabs or burn marks and compare the action with the door open versus closed.
- With power off, reseat the lock connector and check the harness for pinched or green-corroded pins.
- If the lock still will not engage or release, replace the lock assembly and re-test.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Latch | W11307244 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does Loc mean on a Whirlpool dryer?
It is a fault code from the Whirlpool control. It indicates a problem with a door or lid lock. A power reset is the first thing to try.
Can I keep using the dryer while it shows Loc?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear Loc?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Whirlpool dryer codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including GEW9200LW0, GEW9200LW1, GEW9250PW0, LER7646EQ2, LER4634PQ0, LER4634EQ2, GEW9250PW1, LER4634JQ1.