Whirlpool Washer Error Code F0 E4: Meaning and Fix
Also shown as: F0E4, F0-E4
Reading the washer display
On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Whirlpool-family codes are usually read as a letter and number pair, with an E sub-code after it.
Whirlpool is the parent platform for Maytag, KitchenAid and Amana, so many of its control boards and fault codes reappear across those brands. Its panels typically report two-part codes such as F5 E2 or flash sequences on the keypad. The codes apply to model numbers such as GU980SCGB2, GU980SCGQ2 and GEW9200LW0; check the label on your unit to confirm yours.
What causes F0 E4
- Water taps are closed or only partly open
- Inlet hose is kinked or the screen at the hose end is clogged
- Low household water pressure
- Inlet valve coil or solenoid is open or stuck
- Level or flow sensor is giving the control a wrong reading
How to fix it
- Cycle the power: unplug the washer (or switch off its breaker) for five minutes, restore power, then start a short cycle and see whether the code returns.
- Confirm both hot and cold taps are fully open and the supply hoses are not kinked or crushed behind the unit.
- Disconnect the hoses, clean the small screens at the valve inlets and flush each hose into a bucket to check flow.
- Run a short cycle and listen for the valve to click and water to arrive; note whether the level rises.
- If the valve does not open, check its connector and coil, then replace the inlet valve if the coil is open.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Valve | W11165546 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F0 E4 mean on a Whirlpool washer?
It is a fault code from the Whirlpool control. It indicates a problem with the water fill circuit. A power reset is the first thing to try.
Can I keep using the washer while it shows F0 E4?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F0 E4?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Whirlpool washer codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including GHW9100LW1, GHW9150PW0, GHW9200LW0, GHW9100LW2, LSQ8243HQ0, GHW9100LW0, LSQ8543JQ0, LSR7233EQ0.