Kenmore Dryer Error Code PF: Meaning and Fix
Reading the dryer display
On a dryer the code shows in the time-remaining window or as blinking status lights. Write down the characters before you press anything, because starting a new cycle usually clears the display. Check the model-number prefix first: the same Kenmore code can mean different things depending on the manufacturer.
Kenmore is a private label, and the factory that built your unit decides which fault codes it shows. The first digits of a Kenmore model number (110, 417, 665, 795, 796 and so on) tell you whether Whirlpool, LG, Electrolux or Frigidaire made it. Check the model label on your unit before using any chart.
What causes PF
- Low or unstable household voltage, or a loose outlet/plug
- A tripped GFCI or a shared circuit overloaded by other appliances
- A failing power-supply section on the control board
- Loose plug or tripped breaker
How to fix it
- Plug the appliance directly into a wall outlet (no extension cord or surge strip) and check the breaker.
- Measure the outlet voltage; it should sit within roughly 10 percent of the nominal value on the data plate.
- Check the plug and breaker panel.
- Check for scorched plug blades or a loose plug and replace damaged parts.
- Cut power for several minutes, restore it and run a short cycle.
- If the code returns on a healthy supply, have the control board power section tested or replaced.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Dryer Timer Control | WPW10185982 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does error PF mean on a Kenmore dryer?
Power was interrupted during the cycle. Kenmore sells units built by several manufacturers, so the code table that applies depends on who made your model; use the model number to confirm.
Can I keep using my dryer while PF is showing?
Better not to. Running on bad voltage can damage motors and electronics.
How do I clear PF, and can I fix it myself?
Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. This one is usually a do-it-yourself job with basic tools.
Other Kenmore dryer codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including Kenmore Elite 796 series (LG-built), Kenmore 110 series (Whirlpool-built), Kenmore 417 series (Frigidaire-built).