Maytag Dishwasher Error Code F9E2: Meaning and Fix
Reading the dishwasher display
A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Maytag shares the Whirlpool pairing: read the first group, then the sub-code that follows it.
Maytag appliances are built by Whirlpool Corporation on shared platforms, which is why Maytag codes often match Whirlpool ones. Maytag washers, dryers and ranges commonly show F-codes with an E sub-code, or flashing keypad lights. The codes apply to model numbers such as MDB7600AWB, MDB7600AWW and PYE2300AYW; check the label on your unit to confirm yours.
What causes F9E2
- The drain motor (or its connector and wiring) has failed or come loose
- Drain pump motor is failing or its wiring is loose
- Drain hose or standpipe is kinked, clogged or set too high
- Pump filter or impeller is jammed with lint, coins, glass or debris
- Too much detergent created suds that the pump cannot clear
How to fix it
- Cycle the power: switch off the dishwasher breaker for about a minute (or unplug it if you can reach the cord), restore power and run a short cycle.
- Switch the power off and check the drain hose for kinks and make sure the standpipe or disposal knockout is clear.
- Open the pump filter or access panel with a towel and tray ready, and remove anything blocking the pump.
- Run a rinse-and-spin or drain cycle and watch whether water leaves; a humming pump that does not move water points to a seized impeller.
- Replace the drain pump if it is jammed beyond clearing or its motor will not run when power is applied.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Pump Drain | WPW10348269 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F9E2 mean on a Maytag dishwasher?
It is a fault code from the Maytag control. It indicates a problem with the drain system, specifically the drain motor. A power reset is the first thing to try.
Can I keep using the dishwasher while it shows F9E2?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F9E2?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Maytag dishwasher codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including MDB7600AWB, MDB7600AWW, MDB9100AWW, MDB8600AWW, MDB7100AWW, MDB7100AWB, MDB6000AWW, MDB9100AWB.