Maytag Washer Error Code F8 E1: Meaning and Fix
Also shown as: F8E1, F8-E1
Reading the washer display
On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Maytag shares the Whirlpool pairing: read the first group, then the sub-code that follows it.
Maytag appliances are built by Whirlpool Corporation on shared platforms, which is why Maytag codes often match Whirlpool ones. Maytag washers, dryers and ranges commonly show F-codes with an E sub-code, or flashing keypad lights. The codes apply to model numbers such as MDB7600AWB, MDB7600AWW and PYE2300AYW; check the label on your unit to confirm yours.
What causes F8 E1
- The lock mechanism is not confirming that it latched or released
- Door or lid not closing squarely, or the strike is worn or bent
- Control board is not sending or reading the lock signal correctly
- Wiring or connector at the lock has corroded or backed out
How to fix it
- Cycle the power: unplug the washer (or switch off its breaker) for five minutes, restore power, then start a short cycle and see whether the code returns.
- Open and shut the door or lid firmly and make sure nothing (clothing, a rack, a hose) is blocking the strike.
- Look at the lock and strike for cracks, bent tabs or burn marks and compare the action with the door open versus closed.
- With power off, reseat the lock connector and check the harness for pinched or green-corroded pins.
- If the lock still will not engage or release, replace the lock assembly and re-test.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Latch | W11307244 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F8 E1 mean on a Maytag washer?
It is a fault code from the Maytag control. It indicates a problem with a door or lid lock. A power reset is the first thing to try.
Can I keep using the washer while it shows F8 E1?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F8 E1?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Maytag washer codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including MAH4000AWW, PAV2300AWW, MAH5500BWW, MAH3000AWW, FAV6800AWW, MAH8700AWW, MAV6200AWW, PAVT234AWW.