Maytag Washer Error Code F8 E3: Meaning and Fix
Also shown as: F8E3, F8-E3
Reading the washer display
On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Maytag shares the Whirlpool pairing: read the first group, then the sub-code that follows it.
Maytag appliances are built by Whirlpool Corporation on shared platforms, which is why Maytag codes often match Whirlpool ones. Maytag washers, dryers and ranges commonly show F-codes with an E sub-code, or flashing keypad lights. The codes apply to model numbers such as MDB7600AWB, MDB7600AWW and PYE2300AYW; check the label on your unit to confirm yours.
What causes F8 E3
- Drain hose or standpipe is kinked, clogged or set too high
- Too much detergent created suds that the pump cannot clear
- Pump filter or impeller is jammed with lint, coins, glass or debris
- Drain pump motor is failing or its wiring is loose
How to fix it
- Cycle the power: unplug the washer (or switch off its breaker) for five minutes, restore power, then start a short cycle and see whether the code returns.
- Switch the power off and check the drain hose for kinks and make sure the standpipe or disposal knockout is clear.
- Open the pump filter or access panel with a towel and tray ready, and remove anything blocking the pump.
- Run a rinse-and-spin or drain cycle and watch whether water leaves; a humming pump that does not move water points to a seized impeller.
- Replace the drain pump if it is jammed beyond clearing or its motor will not run when power is applied.
- Run a full short cycle or function again and confirm the code stays gone before putting the appliance back into normal use.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Pump Assembly | WP3363394 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does F8 E3 mean on a Maytag washer?
It is a fault code from the Maytag control. It indicates a problem with the drain system. A power reset is the first thing to try.
Can I keep using the washer while it shows F8 E3?
You can try it after a power reset. If the code returns, the affected function may not run properly, so it is worth fixing soon before it causes a bigger failure.
Do I need a technician to clear F8 E3?
Many owners can fix it themselves. Start with the reset and the inspection steps, and only call a technician if the part tests bad and you do not want to replace it.
Other Maytag washer codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including MAH4000AWW, PAV2300AWW, MAH5500BWW, MAH3000AWW, FAV6800AWW, MAH8700AWW, MAV6200AWW, PAVT234AWW.