Home Fault Codes

Overhead Door Opener Error Code Green LED 1 blink: Meaning and Fix

Green LED 1 blink
How Green LED 1 blink appears on a Overhead Door opener display.
Overhead Door opener code Green LED 1 blink: Safe-T-Beam sensor (Genie-built opener part image shown as a generic reference)
Genie Company product image, store.geniecompany.com

Also shown as: Green blinks once

Reading the opener display

A garage door opener reports faults through blinking LEDs on the motor head, a diagnostic window on the logic board, or the wall control. Count the flashes slowly and repeat the count before you decide what you saw. Overhead Door uses red and green LEDs; note which color is flashing and how many times.

Overhead Door openers (Legacy and Odyssey lines) report problems through red and green LED patterns on the powerhead. Count the blinks of the color that is lit and match them to the table. The codes apply to model numbers such as Legacy 850 and Legacy 920; check the label on your unit to confirm yours.

What causes Green LED 1 blink

How to fix it

  1. Set the limits.
  2. Clear the beam.
  3. Check the spring and track.
  4. Retest.

Parts you may need

PartPart no.Buy
Safe-T-Beam sensors37220RFind part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does one green blink mean?

Incomplete limits or obstruction.

Spring?

Check it.

Beam?

Clear it.

Other Overhead Door opener codes

Overhead Door opener code Red LED continuous: remote (Genie-built opener part image shown as a generic reference)Red LED continuousProgramming incompleteOverhead Door opener code Red LED 1 blink: remote (Genie-built opener part image shown as a generic reference)Red LED 1 blinkTransmitter has not learnedOverhead Door opener code Green LED 2 blinks: Safe-T-Beam sensor (Genie-built opener part image shown as a generic reference)Green LED 2 blinksUp limit, wiring or sensor alignmentOverhead Door opener code Green LED 3 blinks: control board (Genie-built opener part image shown as a generic reference)Green LED 3 blinksLimits set backwardsOverhead Door opener code Green LED 4 blinks: wall console (Genie-built opener part image shown as a generic reference)Green LED 4 blinksWall button wire short or reversedOverhead Door opener code Green LED 5 blinks: carriage assembly (Genie-built opener part image shown as a generic reference)Green LED 5 blinksChain/belt too tight or control failure

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including Legacy 850, Legacy 920, Odyssey 1000, 1026, 2029.