Home Fault Codes

Speed Queen Dryer Error Code E8: Meaning and Fix

E8
How E8 appears on a Speed Queen dryer display.
Representative Speed Queen dryer part photo (a heating element unit); the specific component for E8 (ignition fault (gas models)) was not photographed separately
AppliancePartsPros.com product photo

Also shown as: E-8

Reading the dryer display

On a dryer the code shows in the time-remaining window or as blinking status lights. Write down the characters before you press anything, because starting a new cycle usually clears the display. Speed Queen shows two characters such as Ed or E1 on the control.

Speed Queen, from Alliance Laundry Systems, builds commercial-grade home laundry. Its washers and dryers use short error codes such as E1 or Ed, and the control is simpler than most consumer brands, which makes diagnosis more direct. The codes apply to model numbers such as DR7, DC5 and TR7; check the label on your unit to confirm yours.

What causes E8

How to fix it

  1. Turn off the range at the breaker (and gas valve if gas) and let it cool.
  2. Look at the bake and broil elements or igniter for blisters, cracks or breaks.
  3. Test the igniter and gas coil.
  4. Measure the oven sensor at room temperature (about 1080 ohms is typical for a probe) and check the element resistance.
  5. Replace the part that is out of range and reseat connectors that look heat-damaged.
  6. Restore power and run a bake cycle at 350 F, checking the temperature with an oven thermometer.

Parts you may need

PartPart no.Buy
Dryer Heating ElementD510329PFind part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does error E8 mean on a Speed Queen dryer?

The gas dryer failed to ignite after attempts. Exact behavior can vary by model and software version; confirm against your own manual.

Can I keep using my dryer while E8 is showing?

Cooktop burners may keep working, but avoid the oven until the fault is cleared.

How do I clear E8, and can I fix it myself?

Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. Parts here involve electronics, heating or sealed components, so consider a qualified technician if the basic checks do not clear it.

Other Speed Queen dryer codes

Representative Speed Queen dryer part photo (a heating element unit); the specific component for E1 (inlet temperature sensor fault) was not photographed separatelyE1Inlet temperature sensor faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E2 (exhaust temperature sensor fault) was not photographed separatelyE2Exhaust temperature sensor faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E3 (moisture sensor / control fault) was not photographed separatelyE3Moisture sensor / control faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E4 (door switch fault) was not photographed separatelyE4Door switch faultSpeed Queen dryer heating element part photo, the component usually involved when E5 (heating fault) appearsE5Heating faultRepresentative Speed Queen dryer part photo (a heating element unit); the specific component for E6 (restricted airflow) was not photographed separatelyE6Restricted airflow

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including DR7, DC5, ADE9RGS, LDE30.