Frigidaire Washer Error Code E10: Meaning and Fix

How E10 appears on a Frigidaire washer display.

Frigidaire washer E10: example water inlet valve (part 134190200), representative part photo for this code — AppliancePartsPros.com product photo, part 134190200

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Frigidaire models show E, F or i codes depending on the appliance.

Frigidaire is an Electrolux brand and shares platforms with the Electrolux line. Washers and dryers use E codes, ranges use F codes, dishwashers use i codes, and refrigerators show SY codes. The codes apply to model numbers such as FGID2466QF, FFBD2412SW and FFRE4120SW; check the label on your unit to confirm yours.

What causes E10

Hot or cold supply faucet partly closed
Failing water inlet valve solenoid
Clogged screens on the hose ends or inside the inlet valve
Kinked or crushed fill hose
Low household water pressure

How to fix it

Open both faucets fully and confirm water reaches the hoses.
Unplug the washer, pull the fill hoses off the back and rinse the small mesh screens.
Straighten any kinked hose and check the far end for debris.
With the hoses off, run a short cycle: if the valve will not click or flow, replace the inlet valve.
Reconnect, power on and run a rinse to confirm it fills.

Parts you may need

Part	Part no.	Buy
Water inlet valve	134190200	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does the E10 code mean on a Frigidaire washer?

The washer asked for water and the fill did not finish within the time the board allows, so it stopped the cycle. The control never saw the level it was waiting for.

Can I fix the E10 code myself?

Often yes. The most likely repair is the water inlet valve, a part most owners can swap with basic hand tools after unplugging the appliance, and it is usually quicker than a service visit.

How do I clear the E10 code?

Unplug the washer (or switch off its breaker) for five minutes, then plug it back in and run a short rinse or drain cycle. If E10 comes back, the underlying fault is still there; start with this: hot or cold supply faucet partly closed.

Other Frigidaire washer codes

Frigidaire washer E11: example water inlet valve (part 134190200), representative part photo for this code

E11Fill time too long

Frigidaire washer E13: example water inlet valve (part 134190200), representative part photo for this code

E13Water leak / valve leaking by

Frigidaire washer E20: example drain pump (part 137108000), representative part photo for this code

E20Drain problem

Frigidaire washer E21: example drain pump (part 137108000), representative part photo for this code

E21Drain pump circuit fault

Frigidaire washer E23: example drain pump (part 137108000), representative part photo for this code

E23Drain pump motor error

Frigidaire washer E31: example main control board (part 5304512731), representative part photo for this code

E31Water level sensor out of range

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including FFFW5000VW, FFFS5115PA, FFTW4120SW, FAFW3801LW.