Frigidaire Washer Error Code E23: Meaning and Fix

How E23 appears on a Frigidaire washer display.

Frigidaire washer E23: example drain pump (part 137108000), representative part photo for this code — AppliancePartsPros.com product photo, part 137108000

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Frigidaire models show E, F or i codes depending on the appliance.

Frigidaire is an Electrolux brand and shares platforms with the Electrolux line. Washers and dryers use E codes, ranges use F codes, dishwashers use i codes, and refrigerators show SY codes. The codes apply to model numbers such as FGID2466QF, FFBD2412SW and FFRE4120SW; check the label on your unit to confirm yours.

What causes E23

Seized pump bearing
Open pump winding
Control board output failure
Corroded harness plug

How to fix it

Disconnect power and inspect the pump filter for blockage.
Check the pump plug for water damage or green corrosion.
Test the pump windings for continuity.
Replace the pump, then run a drain-and-spin test.

Parts you may need

Part	Part no.	Buy
Drain pump	137108000	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does the E23 code mean on a Frigidaire washer?

The board senses the drain pump is not responding as it should, typically a seized or electrically failed pump.

Can I fix the E23 code myself?

Often yes. The most likely repair is the drain pump, a part most owners can swap with basic hand tools after unplugging the appliance, and it is usually quicker than a service visit.

How do I clear the E23 code?

Unplug the washer (or switch off its breaker) for five minutes, then plug it back in and run a short rinse or drain cycle. If E23 comes back, the underlying fault is still there; start with this: seized pump bearing.

Other Frigidaire washer codes

Frigidaire washer E10: example water inlet valve (part 134190200), representative part photo for this code

E10Water fill problem

Frigidaire washer E11: example water inlet valve (part 134190200), representative part photo for this code

E11Fill time too long

Frigidaire washer E13: example water inlet valve (part 134190200), representative part photo for this code

E13Water leak / valve leaking by

Frigidaire washer E20: example drain pump (part 137108000), representative part photo for this code

E20Drain problem

Frigidaire washer E21: example drain pump (part 137108000), representative part photo for this code

E21Drain pump circuit fault

Frigidaire washer E31: example main control board (part 5304512731), representative part photo for this code

E31Water level sensor out of range

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including FFFW5000VW, FFFS5115PA, FFTW4120SW, FAFW3801LW.