Frigidaire Washer Error Code E11: Meaning and Fix

How E11 appears on a Frigidaire washer display.

Frigidaire washer E11: example water inlet valve (part 134190200), representative part photo for this code — AppliancePartsPros.com product photo, part 134190200

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Frigidaire models show E, F or i codes depending on the appliance.

Frigidaire is an Electrolux brand and shares platforms with the Electrolux line. Washers and dryers use E codes, ranges use F codes, dishwashers use i codes, and refrigerators show SY codes. The codes apply to model numbers such as FGID2466QF, FFBD2412SW and FFRE4120SW; check the label on your unit to confirm yours.

What causes E11

Weak water pressure at the faucet
Pressure switch tube pinched or leaking air
Inlet valve that opens only partway
Partly blocked inlet screens

How to fix it

Check that another tap in the house has normal pressure.
Clean both inlet screens at the washer and at the faucet end.
Look at the small clear air tube running to the water level switch for kinks, cracks or water inside it.
Swap in a new inlet valve if screens are clean and pressure is fine.

Parts you may need

Part	Part no.	Buy
Water inlet valve	134190200	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does the E11 code mean on a Frigidaire washer?

The tub kept filling longer than expected, or the level reading stayed low. It is closely related to E10 and normally points to restricted incoming water.

Can I fix the E11 code myself?

Often yes. The most likely repair is the water inlet valve, a part most owners can swap with basic hand tools after unplugging the appliance, and it is usually quicker than a service visit.

How do I clear the E11 code?

Unplug the washer (or switch off its breaker) for five minutes, then plug it back in and run a short rinse or drain cycle. If E11 comes back, the underlying fault is still there; start with this: weak water pressure at the faucet.

Other Frigidaire washer codes

Frigidaire washer E10: example water inlet valve (part 134190200), representative part photo for this code

E10Water fill problem

Frigidaire washer E13: example water inlet valve (part 134190200), representative part photo for this code

E13Water leak / valve leaking by

Frigidaire washer E20: example drain pump (part 137108000), representative part photo for this code

E20Drain problem

Frigidaire washer E21: example drain pump (part 137108000), representative part photo for this code

E21Drain pump circuit fault

Frigidaire washer E23: example drain pump (part 137108000), representative part photo for this code

E23Drain pump motor error

Frigidaire washer E31: example main control board (part 5304512731), representative part photo for this code

E31Water level sensor out of range

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including FFFW5000VW, FFFS5115PA, FFTW4120SW, FAFW3801LW.