Kenmore Dishwasher Error Code F3E3: Meaning and Fix
Also shown as: F3-E3
Reading the dishwasher display
A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Check the model-number prefix first: the same Kenmore code can mean different things depending on the manufacturer.
Kenmore is a private label, and the factory that built your unit decides which fault codes it shows. The first digits of a Kenmore model number (110, 417, 665, 795, 796 and so on) tell you whether Whirlpool, LG, Electrolux or Frigidaire made it. Check the model label on your unit before using any chart.
What causes F3E3
- A temperature or level sensor that has drifted out of range or failed open/short
- A control board input that misreads the sensor signal
- Scale on the sensor body
- A loose or corroded sensor connector or broken lead wire
How to fix it
- Unplug the appliance and locate the sensor named for this fault in your service sheet or parts diagram.
- Inspect the sensor, its lead wire and plug for damage, moisture or corrosion; clean contacts and reseat the connector.
- Clean the sensor with a descaling cycle.
- Measure the sensor resistance with a multimeter and compare it with the value expected at room temperature.
- Replace the sensor if the reading is open, shorted or far from spec.
- Power back up and run a short cycle to confirm the code does not return.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Dishwasher Turbidity Sensor | WPW10705575 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does error F3E3 mean on a Kenmore dishwasher?
Reported temperature does not match what the control expects. Kenmore sells units built by several manufacturers, so the code table that applies depends on who made your model; use the model number to confirm.
Can I keep using my dishwasher while F3E3 is showing?
Often yes for a short while, but with reduced performance because the control is running blind; get it checked before it causes a heating or flooding problem.
How do I clear F3E3, and can I fix it myself?
Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. Parts here involve electronics, heating or sealed components, so consider a qualified technician if the basic checks do not clear it.
Other Kenmore dishwasher codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including Kenmore Elite 665 series (Bosch/Whirlpool/Electrolux-built), Kenmore 665.1 series (Whirlpool-built), Kenmore 630 / 665.13 series (Electrolux-built).