Kenmore Dishwasher Error Code i30: Meaning and Fix
Also shown as: I30
Reading the dishwasher display
A dishwasher reports its fault in the display window, or by blinking a cycle light a set number of times with a pause between groups. Count the blinks and pauses before opening the door. Check the model-number prefix first: the same Kenmore code can mean different things depending on the manufacturer.
Kenmore is a private label, and the factory that built your unit decides which fault codes it shows. The first digits of a Kenmore model number (110, 417, 665, 795, 796 and so on) tell you whether Whirlpool, LG, Electrolux or Frigidaire made it. Check the model label on your unit before using any chart.
What causes i30
- Water collecting in the base from a leaking door gasket, hose clamp or spray-arm seal
- Overfilled detergent dispenser causing suds
- Overfilling caused by a faulty inlet valve or too much detergent/foam
- A float switch or leak sensor stuck or tripped by residual water
How to fix it
- Unplug the appliance and shut off the water supply before you investigate.
- Pull the unit out (or remove the toe-kick) and look for wet spots, damp insulation and drips under every hose connection.
- Use less detergent and wipe the base clean.
- Soak up any water in the base pan, then wipe the float and sensor area clean so they move freely.
- Replace worn gaskets, tighten or replace hose clamps and use only the recommended amount of low-sudsing detergent.
- Restore power, run a short test cycle and dry-check the floor and pan afterwards.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Dishwasher Gasket | 8581548276014 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does error i30 mean on a Kenmore dishwasher?
Water detected in the base pan, so the machine stops. Kenmore sells units built by several manufacturers, so the code table that applies depends on who made your model; use the model number to confirm.
Can I keep using my dishwasher while i30 is showing?
No. Leave the water supply off until the leak is traced, to avoid floor and cabinet damage.
How do I clear i30, and can I fix it myself?
Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. Parts here involve electronics, heating or sealed components, so consider a qualified technician if the basic checks do not clear it.
Other Kenmore dishwasher codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including Kenmore Elite 665 series (Bosch/Whirlpool/Electrolux-built), Kenmore 665.1 series (Whirlpool-built), Kenmore 630 / 665.13 series (Electrolux-built).