Speed Queen Washer Error Code Ed: Meaning and Fix
Also shown as: Ed
Reading the washer display
On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Speed Queen shows two characters such as Ed or E1 on the control.
Speed Queen, from Alliance Laundry Systems, builds commercial-grade home laundry. Its washers and dryers use short error codes such as E1 or Ed, and the control is simpler than most consumer brands, which makes diagnosis more direct. The codes apply to model numbers such as DR7, DC5 and TR7; check the label on your unit to confirm yours.
What causes Ed
- A door latch or lock assembly that is worn, broken or not engaging
- Wiring or connector damage between the latch and the control board
- A door switch or strike that is misaligned or has failed
- Door catch worn out
How to fix it
- Open and firmly close the door, checking that nothing (towel, rack, detergent box, clothing) is keeping it from latching.
- Look at the latch hook, strike and door seal for cracks, bent metal or detergent build-up and clean or straighten as needed.
- Close the door firmly and check the latch hook.
- Switch the power off and inspect the latch connector and harness for loose pins or burn marks.
- Test the door switch or lock for continuity with a multimeter while operating the latch by hand.
- Replace the latch or switch assembly if it fails, then run a short cycle to confirm the door locks and the code clears.
Parts you may need
| Part | Part no. | Buy |
|---|---|---|
| Washer Lid Lock Kit | 205222 | Find part |
Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.
Questions
What does error Ed mean on a Speed Queen washer?
The door lock could not engage or be sensed, so the cycle cannot start. Exact behavior can vary by model and software version; confirm against your own manual.
Can I keep using my washer while Ed is showing?
No. The machine will refuse to run, and forcing a door interlock is unsafe.
How do I clear Ed, and can I fix it myself?
Cancel the program, switch the appliance off and leave it unplugged (or the breaker off) for about five minutes, then restart. The code only stays cleared if the underlying problem is fixed, so work through the steps above. This one is usually a do-it-yourself job with basic tools.
Other Speed Queen washer codes
Sources
Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.
Applies to models including TR7, TC5, FF7, LWNA52, AWNE92.