Amana furnace codes

A furnace reports faults on a small status LED on the control board, seen through the sight glass in the blower door, or on a two-digit display. Watch a full cycle of the pattern and count the flashes, including the pause between groups, before you decide what you saw. The code chart is on the label inside the blower door. Amana models often flash lights instead of printing text, so count the flashes.

Models covered: AM9S80, AC9S80.

All 11 codes

E0Ignition lockout after repeated failed ignition (pro repair)E1Pressure switch closed at the start of the heating cycle (pro repair)E2Pressure switch circuit not closed (pro repair)E3Primary limit circuit open (pro repair)E4Flame sensed with no call for heat (pro repair)E5Open fuse or short in low voltage wiring (DIY)E6Low flame sense signal (pro repair)EbGas valve not energized when it should be (pro repair)ECGas valve energized when it should not be (pro repair)E10Grounding fault or poor neutral connection (pro repair)E11Open rollout switch (pro repair)

About Amana codes

Amana is a Whirlpool Corporation brand sold mostly through builder and value channels. Its entry-level washers, dryers and ranges use the simpler Whirlpool-family control boards, so the codes are short and often shown as flashing lights. The codes apply to model numbers such as ADB1200AWS, ADB2200AWS and NDE2330AYW; check the label on your unit to confirm yours.