Bryant Furnace Continuous Off: Meaning and Fix

A furnace reports faults on a small status LED on the control board, seen through the sight glass in the blower door, or on a two-digit display. Watch a full cycle of the pattern and count the flashes, including the pause between groups, before you decide what you saw. The code chart is on the label inside the blower door.

This page lists the fault codes this brand documents, with likely causes and a short repair path. The codes apply to model numbers such as 310AAV; check the label on your unit to confirm yours.

If you smell gas, leave the building and call your gas utility from outside; do not touch switches or the furnace. Switch the furnace power off before you open the blower door or touch the igniter or flame sensor, and call a licensed HVAC technician if you are not sure.

The code meaning comes from the manufacturer document listed under Sources. The causes and steps below are general troubleshooting guidance, not the manufacturer's service procedure.

1. Make sure the furnace power switch, usually on or near the furnace, is on and the breaker has not tripped.
2. Check that the blower door is fully seated so its door switch is pressed.
3. Check that the thermostat has fresh batteries if it uses them and is set to heat.
4. A technician should confirm 115 VAC at L1 and L2 and 24 VAC at SEC-1 and SEC-2 before replacing any part.
5. Restore power and run a heating cycle. If the code returns, call a licensed HVAC technician and give them the code, the board label and the furnace model number.

What does Continuous Off mean on a Bryant furnace?

The status LED on the Bryant furnace control board is not lit at all. That means the control is not getting power, so the furnace will not run.

Is a dark LED a bad control board?

Not necessarily. Most dark LEDs are a tripped breaker, an off switch or a blower door that is not fully closed. Rule those out first. If power is confirmed at the board and the LED is still dark, the board or transformer is the likely fault.

When should I call a technician?

Call a licensed HVAC technician for anything involving gas, the pressure switch, the limit or rollout switches, the igniter, the flame sensor or a control board replacement, or if the code keeps coming back after the simple checks.

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including 310AAV.

• https://www.manualslib.com/manual/22340/Bryant-310aav.html