Electrolux Washer Error Code E20: Meaning and Fix

How E20 appears on a Electrolux washer display.

Electrolux washer E20: example drain pump (part 137108000), representative part photo for this code — AppliancePartsPros.com product photo, part 137108000

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Electrolux uses the same E, F and i prefixes as Frigidaire.

Electrolux builds the platforms behind both its own line and Frigidaire, so its codes line up closely with Frigidaire ones. Look for E codes on laundry, F codes on ranges and i codes on dishwashers. The codes apply to model numbers such as EIDW5905JS, EDSH4944AS and EFME527UIW; check the label on your unit to confirm yours.

What causes E20

Clogged drain pump filter
Kinked or blocked drain hose
Worn drain pump
Standpipe too high or clogged

How to fix it

Turn off power and place a shallow pan and towels at the front lower filter door.
Drain and unscrew the filter; remove lint and debris.
Check that the drain hose is not kinked or too deep in the standpipe.
Run drain and spin; if you hear no pump, replace the pump.

Parts you may need

Part	Part no.	Buy
Drain pump	137108000	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does the E20 code mean on a Electrolux washer?

The tub did not empty within the allowed time. Lint, coins or a kinked hose are the usual reasons.

Can I fix the E20 code myself?

Often yes. The most likely repair is the drain pump, a part most owners can swap with basic hand tools after unplugging the appliance, and it is usually quicker than a service visit.

How do I clear the E20 code?

Unplug the washer (or switch off its breaker) for five minutes, then plug it back in and run a short rinse or drain cycle. If E20 comes back, the underlying fault is still there; start with this: clogged drain pump filter.

Other Electrolux washer codes

Electrolux washer E10: example water inlet valve (part 134190200), representative part photo for this code

E10Water inlet problem

Electrolux washer E13: example water inlet valve (part 134190200), representative part photo for this code

E13Water leak detected

Electrolux washer E21: example drain pump (part 137108000), representative part photo for this code

E21Drain pump fault

Electrolux washer E40: example door lock assembly (part 131763256), representative part photo for this code

E40Door open

Electrolux washer E41: example door lock assembly (part 131763256), representative part photo for this code

E41Door lock fault

Electrolux washer E43: example door lock assembly (part 131763256), representative part photo for this code

E43Door lock circuit fault

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including EFLS527UIW, EFLW427UIW, EFLS617STT, EWFLS70JIW.