Electrolux Washer Error Code E21: Meaning and Fix

How E21 appears on a Electrolux washer display.

Electrolux washer E21: example drain pump (part 137108000), representative part photo for this code — AppliancePartsPros.com product photo, part 137108000

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Electrolux uses the same E, F and i prefixes as Frigidaire.

Electrolux builds the platforms behind both its own line and Frigidaire, so its codes line up closely with Frigidaire ones. Look for E codes on laundry, F codes on ranges and i codes on dishwashers. The codes apply to model numbers such as EIDW5905JS, EDSH4944AS and EFME527UIW; check the label on your unit to confirm yours.

What causes E21

Debris jammed in the impeller
Failed pump motor
Loose pump connector
Board output fault

How to fix it

Unplug the washer and clear the pump housing.
Turn the impeller by hand; it should spin freely.
Reseat the pump plug and look for scorching.
Test the pump windings; replace if open.
Run a spin to verify drainage.

Parts you may need

Part	Part no.	Buy
Drain pump	137108000	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does the E21 code mean on a Electrolux washer?

The control does not see the drain pump working as expected, which can be a jam or an electrical failure.

Can I fix the E21 code myself?

Often yes. The most likely repair is the drain pump, a part most owners can swap with basic hand tools after unplugging the appliance, and it is usually quicker than a service visit.

How do I clear the E21 code?

Unplug the washer (or switch off its breaker) for five minutes, then plug it back in and run a short rinse or drain cycle. If E21 comes back, the underlying fault is still there; start with this: debris jammed in the impeller.

Other Electrolux washer codes

Electrolux washer E10: example water inlet valve (part 134190200), representative part photo for this code

E10Water inlet problem

Electrolux washer E13: example water inlet valve (part 134190200), representative part photo for this code

E13Water leak detected

Electrolux washer E20: example drain pump (part 137108000), representative part photo for this code

E20Drain problem

Electrolux washer E40: example door lock assembly (part 131763256), representative part photo for this code

E40Door open

Electrolux washer E41: example door lock assembly (part 131763256), representative part photo for this code

E41Door lock fault

Electrolux washer E43: example door lock assembly (part 131763256), representative part photo for this code

E43Door lock circuit fault

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including EFLS527UIW, EFLW427UIW, EFLS617STT, EWFLS70JIW.