Electrolux Washer Error Code E40: Meaning and Fix

How E40 appears on a Electrolux washer display.

Electrolux washer E40: example door lock assembly (part 131763256), representative part photo for this code — AppliancePartsPros.com product photo, part 131763256

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Electrolux uses the same E, F and i prefixes as Frigidaire.

Electrolux builds the platforms behind both its own line and Frigidaire, so its codes line up closely with Frigidaire ones. Look for E codes on laundry, F codes on ranges and i codes on dishwashers. The codes apply to model numbers such as EIDW5905JS, EDSH4944AS and EFME527UIW; check the label on your unit to confirm yours.

What causes E40

Door not shut fully or clothes caught in the seal
Door switch wiring damage
Worn latch hook or striker

How to fix it

Reopen the door, clear the seal and shut it firmly.
Look for a cracked latch or broken hook.
Listen for the lock click as the cycle starts.
If no click, replace the door lock assembly.

Parts you may need

Part	Part no.	Buy
Door lock assembly	131763256	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does the E40 code mean on a Electrolux washer?

The control is not receiving a closed-door signal, so the washer will not start or lock.

Can I fix the E40 code myself?

Often yes. The most likely repair is the door lock assembly, a part most owners can swap with basic hand tools after unplugging the appliance, and it is usually quicker than a service visit.

How do I clear the E40 code?

Unplug the washer (or switch off its breaker) for five minutes, then plug it back in and run a short rinse or drain cycle. If E40 comes back, the underlying fault is still there; start with this: door not shut fully or clothes caught in the seal.

Other Electrolux washer codes

Electrolux washer E10: example water inlet valve (part 134190200), representative part photo for this code

E10Water inlet problem

Electrolux washer E13: example water inlet valve (part 134190200), representative part photo for this code

E13Water leak detected

Electrolux washer E20: example drain pump (part 137108000), representative part photo for this code

E20Drain problem

Electrolux washer E21: example drain pump (part 137108000), representative part photo for this code

E21Drain pump fault

Electrolux washer E41: example door lock assembly (part 131763256), representative part photo for this code

E41Door lock fault

Electrolux washer E43: example door lock assembly (part 131763256), representative part photo for this code

E43Door lock circuit fault

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including EFLS527UIW, EFLW427UIW, EFLS617STT, EWFLS70JIW.