Frigidaire Washer Error Code E45: Meaning and Fix

How E45 appears on a Frigidaire washer display.

Frigidaire washer E45: example door lock assembly (part 131763256), representative part photo for this code — AppliancePartsPros.com product photo, part 131763256

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. Frigidaire models show E, F or i codes depending on the appliance.

Frigidaire is an Electrolux brand and shares platforms with the Electrolux line. Washers and dryers use E codes, ranges use F codes, dishwashers use i codes, and refrigerators show SY codes. The codes apply to model numbers such as FGID2466QF, FFBD2412SW and FFRE4120SW; check the label on your unit to confirm yours.

What causes E45

Open lock solenoid
Loose connector at the control board
Damaged harness

How to fix it

Disconnect power and unplug the lock to inspect pins.
Measure the lock resistance; infinite means a dead lock.
Look at the wiring for pinch points near the door hinge.
Replace the lock assembly, then recheck.

Parts you may need

Part	Part no.	Buy
Door lock assembly	131763256	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

What does the E45 code mean on a Frigidaire washer?

The control reads an electrical problem in the door-lock circuit, such as an open or shorted lock coil.

Can I fix the E45 code myself?

Start with the free checks (power reset, connectors, obvious blockages). The likely repair involves the door lock assembly and live-circuit testing, so if the code returns, a qualified technician is the safer call.

How do I clear the E45 code?

Unplug the washer (or switch off its breaker) for five minutes, then plug it back in and run a short rinse or drain cycle. If E45 comes back, the underlying fault is still there; start with this: open lock solenoid.

Other Frigidaire washer codes

Frigidaire washer E10: example water inlet valve (part 134190200), representative part photo for this code

E10Water fill problem

Frigidaire washer E11: example water inlet valve (part 134190200), representative part photo for this code

E11Fill time too long

Frigidaire washer E13: example water inlet valve (part 134190200), representative part photo for this code

E13Water leak / valve leaking by

Frigidaire washer E20: example drain pump (part 137108000), representative part photo for this code

E20Drain problem

Frigidaire washer E21: example drain pump (part 137108000), representative part photo for this code

E21Drain pump circuit fault

Frigidaire washer E23: example drain pump (part 137108000), representative part photo for this code

E23Drain pump motor error

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including FFFW5000VW, FFFS5115PA, FFTW4120SW, FAFW3801LW.