LG Washer Error Code IE: Meaning and Fix

How IE appears on a LG washer display.

Water inlet valve for an LG washer, a part commonly involved in the IE code — Sears PartsDirect product image (LG OEM part AJU75152601)

Also shown as: E02, E10

Reading the washer display

On a washer the code appears on the digital display or as a pattern of flashing cycle lights. Note it exactly, including any dashes or sub-codes, then unplug the washer for five minutes and run a short drain cycle to see whether it returns. LG codes are short letter pairs; a capital O differs from a zero.

LG appliances show short alphabetic codes (OE, IE, UE on washers, Er plus letters on refrigerators) and, on ThinQ models, a Smart Diagnosis option. LG also builds many Kenmore Elite units. The codes apply to model numbers such as LDF7774ST, LDT5678SS and DLEX3900B; check the label on your unit to confirm yours.

What causes IE

Faucets turned off or the water supply cut at the house
Failed water inlet valve
Clogged screen filter at the hose end
Kinked or crushed inlet hose
Frozen supply line in winter

How to fix it

Confirm both hot and cold faucets are fully open (turn counterclockwise) and that another tap in the house is running.
Pull the washer out slightly and straighten any bend in the inlet hoses.
Shut off the faucets, unscrew each hose from the back of the washer, and pull out the small mesh filter with pliers.
Rinse sand and rust off the filter, refit it, and reconnect the hoses hand-tight plus a quarter turn.
In freezing weather wrap the faucet with a hot wet cloth for five minutes and thaw the hoses in water below 120 F.
If water flows freely at the hoses and the error repeats, the inlet valve is likely failing.

Parts you may need

Part	Part no.	Buy
Water inlet valve	AJU75152601	Find part
Water inlet hose	5214EA3004D	Find part

Part numbers are OEM references; confirm fit by your model number before ordering. Some links are affiliate links; we may earn a commission at no extra cost to you.

Questions

Why does IE mostly happen in winter?

Supply lines and hoses can freeze, which blocks flow. Thaw them gently with warm water, never boiling water.

Could low water pressure cause IE?

Yes. Very low household pressure fills the tub too slowly and trips the fill timer, so check flow at a nearby tap.

Can I clean the inlet filter myself?

Yes. Close the faucet, disconnect the hose, remove the mesh with pliers or tweezers and rinse it. Never run the washer without the filter in place.

Other LG washer codes

Drain pump for an LG washer, a part commonly involved in the OE code

OEDrain error

Generic LG washer image (main control board); the UE code is not tied to one single part

UEUnbalanced load error

Door lock assembly for an LG washer, a part commonly involved in the dE code

dEDoor not closed error

Door lock assembly for an LG washer, a part commonly involved in the dE2 code

dE2Door closed but not locked

Drive motor for an LG washer, a part commonly involved in the LE code

LELocked motor error

Water inlet valve for an LG washer, a part commonly involved in the FE code

FEOverfill error

Sources

Part numbers are OEM references; confirm fit by your model number before ordering. Meanings compiled from manufacturer and parts-retailer documentation; see sources below. Unplug the appliance before opening it.

Applies to models including WM3400CW, WM4000HWA, WT7300CV, WM3600HWA, WKEX200HBA.